Caring for seasonally used starter batteries
Some batteries are only used seasonally - those in classic cars, motorcycles, boats, jet skis or snowmobiles, but also in certain utility, security or clearance vehicles.
If a battery is installed in a vehicle that is not used for a long time, it will …
Causal research for better purchasing decisions
Batteries age and fail. Sometimes it happens faster than you planned.
If you know the cause of premature aging, you have a chance to make a more appropriate choice now: A battery that fits your technical requirements, intended use, and individual habits …
Removing the starter battery or motorcycle battery
If you want to remove a start-stop battery: inform the vehicle system before removal.
First disconnect the negative cable (usually black), also called ground or earth, from the negative terminal of the battery.
Then remove the positive cable (usually red) from the positive terminal of the battery.
What is the point of vibration-proofing a starter battery?
Especially in trucks and other high-displacement commercial vehicles with diesel engines, there are strong vibrations that cause the battery to age prematurely. Our truck batteries in SHD versions are vibration resistant according to V3, like the intAct …
What does pole growth on the battery mean?
Whitish-grey deposits on the poles, so-called "pole growth", is caused by strong sulphation on the plates.
Tip: Always ensure a good state of charge.
What is short circuit and how do I prevent it?
Short-circuiting occurs when the two terminals or plates of a battery are accidentally connected together. This can happen if the separator between the plates is damaged by vibration, for example, or if excessive battery sludge builds up, closing the …
Charge filled and charged battery before installation.
A battery that is not fully charged when installed will not reach its full capacity in the future and will have a significantly shortened service life.
Even factory-filled and charged batteries can lose charge during storage. We recommend that you also …
Batteries in trucks, commercial vehicles, agricultural machines and buses have to be vibration resistant due to engine vibrations. Our truck batteries in SHD versions are vibration resistant according to V3, like intAct Start-Power NG Truck, or V4, like …
Check battery externally before charging
If the battery box is damaged or deformed, replace the battery.
Clean dirty terminals with a wire brush.
Remove oils, fluids or other deposits.
For batteries with plugs, check fluid level and refill to MAX with distilled water if necessary.
In a nutshell, the battery generates electricity, which it delivers to the consumers. It is charged and is ready again.
So far, so good. Meanwhile, a bit of chemistry happens inside the battery.
Current flow
In principle, current flows between a positive …